What is the manufacturing process of silicone heating wire?
Release Date:
2022-11-21
Author:
Abstract:
Rubber filter screens typically consist of 20–40 mesh rubber filter plates and 60–100 mesh fine stainless steel rubber filter meshes. Some manufacturers prefer not to use rubber filters for direct extrusion, as this can increase extrusion speed and, in some cases, reduce the risk of overheating and scorching near the rubber filter plates. However, the use of rubber filters should not be overlooked, as they play a crucial role in removing impurities and undispersed filler particles from the rubber. At the same time, rubber filters also help eliminate air entrapped in the rubber during mixing and re‑mixing, particularly in softer rubbers.

Because silicone heating wires exhibit only slight thermoplasticity, they are not easily affected by flow stresses or shear strains in the uncured state; therefore, the design of the filter plate is not critical. Most filter‑plate designs are suitable for processing silicone heating wires.
In terms of equipment selection, since we do not have any dedicated production facilities for silicone heating‑wire cables, we have no alternative. Among the three continuous vulcanization lines currently in use, the equipment suitable for manufacturing silicone heating wires includes the Φ65/Φ90 steam‑based continuous vulcanization extruder and the PLCV salt‑bath continuous vulcanization extruder.
Since silicone heating‑wire cables are not part of our standard product line, we have always had to proceed cautiously when manufacturing them. For insulation extrusion, we use Φ65/Φ90 steam‑cured continuous extruders and PLCV continuous vulcanization extruders. However, the Φ65/Φ90 steam‑cured rubber extruder cannot connect the expansion tube to the die head; once connected, the die‑head temperature rises rapidly under steam heating, causing the silicone heating wire to cure prematurely during extrusion. Consequently, in actual production, we do not attach the expansion tube to the die head but instead operate the steam system in an open configuration. This limits the steam pressure, thereby reducing production speed and resulting in significant steam wastage. When using the PLCV unit for insulation extrusion, extrusion proceeds without major issues as long as the extrusion temperature is properly controlled. Only a pressure of 0.2 MPa—or no pressure at all—can meet the product’s specifications.
The insulation and jacket are easy to strip, which means the two‑layer co‑extrusion process commonly used in single‑core cable production is no longer necessary. When the insulation extrusion is ready for jacket extrusion, a problem arises: during the secondary vulcanization of the silicone‑heated wire’s insulation layer, the gas released can lift the insulation and become trapped inside the inner mold. After jacket extrusion, the jacket bubbles and bursts. Through repeated trials, we applied a longitudinal wrap of nonwoven fabric over the insulated core, providing a reservoir for the gases released during the secondary vulcanization of the silicone‑heated wire’s insulation.
Given past successes, we have blindly assumed that nonwoven fabric could resolve the issues in the production of silicone heating‑wire cables. However, in reality, not all such cables can yield qualified products simply by wrapping the insulation layer with nonwoven fabric. Even when nonwoven fabric is used to wrap the cable after it has been formed, insufficient filling during cable formation leads to inadequate melt pressure during sheath extrusion, preventing the silicone heating wire from being properly injected into the unfilled gaps. Moreover, if a vulcanization tube is employed for pressurized curing, condensation may occur.
Recommended Reading
Spring Heating Wire: A Warm and Harmonious Companion for the Family
2025-02-28
PVC Heating Wire: Bringing Warmth to Your Home
2025-02-18
Aluminum Foil Heating Pad: Bringing Warmth to the Chilly Season
2025-02-08