What are the selection criteria for electric heating plates?
Release Date:
2021-02-18
Author:
Abstract:
1. Electric heating tapes are typically used for pipeline trace heating and can also be wrapped around small vessels for heat tracing. Electric heating mats are employed for thermal insulation and heat tracing of storage tanks and vessels.
2. Series‑type electric heating elements must have their design power verified against the actual pipe lengths on site prior to installation, which often necessitates design revisions; therefore, they should not be selected.
3. Parallel-connected electric heating plates
Parallel‑type electric heating elements are available in standard and enhanced versions. The enhanced version features an insulating coating applied over the standard element, providing superior mechanical strength and excellent corrosion resistance; however, its thermal conductivity is slightly lower than that of the standard type. It is suitable for underground applications or environments with corrosive gases.
Product Features:
A. Power phase per unit length
Wait—temperature cannot be adjusted. When in use, do not exceed the heating element’s maximum operating temperature; otherwise, the insulating material may age prematurely or be damaged.
Not good.
B. Since the power per unit length is uniform, the heating elements can be cut on-site to any length, facilitating installation; however, overlapping or crossing of the heating strips should be avoided.
C. To ensure effective heat tracing, it should be used in conjunction with a temperature controller whenever possible. The switch inside the power supply box provides protection against overload, short circuit, and leakage current. When the surface temperature exceeds the set value, the temperature controller can either issue an alarm signal or trip the power switch.
D. Electric heating tapes may be designed for single-point power supply and unidirectional heat output, or for single-point power supply and bidirectional heat output. The maximum allowable heating length varies among different models and specifications and depends on the manufacturer; it shall comply with the manufacturer’s product specifications.
4. Temperature
Product Features of the Automatic Control Electric Heating Plate:
A. A temperature‑self‑regulating electric heating sheet is equivalent to several resistors connected in parallel and can be cut to any desired length during use.
B. Although the pipe diameters, insulation thicknesses, and fluid flow conditions vary along the same pipeline, trace heating can still be implemented within the same loop.
C. There are components in the pipeline.
When the temperature changes, the thermostatically controlled heating element can adapt to a wide range of temperatures.
D. The external surface at the connection between valves and fittings may be wrapped with a laminated wrap, which will not cause the material to overheat, nor will it overheat itself.
E. It can be used in conjunction with a temperature controller to further leverage the advantages of the electric heating plate’s automatic temperature control. Additionally, when the heating plate fails due to wear and tear and can no longer regulate temperature, it can also prevent the temperature from exceeding the material’s conveying temperature.
F. Design selection is convenient, especially for projects involving complex heat loss calculations and challenging construction requirements.
G. Heating cable length for temperature-controlled electric heating elements - Generally no more than 80m This is because the heat tracing is too long, resulting in an excessively high starting current. ( Generally, it is the normal operating current. 6~7 times )。
Recommended Reading
Spring Heating Wire: A Warm and Harmonious Companion for the Family
2025-02-28
PVC Heating Wire: Bringing Warmth to Your Home
2025-02-18
Aluminum Foil Heating Pad: Bringing Warmth to the Chilly Season
2025-02-08