Aging of Electric Heating Tubes and Remedial Measures
Release Date:
2021-03-05
Author:
Abstract:
Phenomena of Aging and Damage in Electric Heating Tubes and Safe Operating Procedures
After heat treatment, the wear resistance and hardness of the heating tube’s surface are enhanced without affecting its compositional integrity. Clean the metal tube’s surface and keep it free of contaminants; degrease the heating tube’s surface by immersing the metal tube completely in a degreasing solution. The degreasing solution… pH The value should be 13 Approximately, the duration should be no less than half an hour. After degreasing, rinse with clean water. Proceed with pickling; the pickling solution’s… pH The value is 3 Around, the processing time does not exceed 10 minutes; pickling is carried out with clean water; tank solution pH Value is in 2-4 Between, processing time 10 About a few minutes; once it turns black, no rinsing is required—simply dry and oil it.
If the resistance wire of an anti-corrosion electric heating tube is reused after multiple repairs, it can also pose a fire hazard. When using such a tube, do not place it near flammable or explosive materials; maintain a safe clearance. Additionally, the tube must be mounted on a non‑combustible base. To ensure safe disconnection of the power supply, the electrical circuit must meet the heater’s rated capacity. A plug must be installed on the heating tube’s power cord, and the heating element’s terminals should never be inserted directly into an outlet.
If any aging or damage is detected, the component should be replaced promptly. Do not operate the electric heating tube without a fuse in the circuit. When using corrosion‑resistant electric heating tubes, ensure they are supervised at all times; unplug them when disconnecting, and always remove the heater from the power supply during a power outage—never forget this. Avoid using resistance wire that has been repaired multiple times to prevent further degradation. At the installation location of corrosion‑resistant electric heating tubes, take care to prevent solid particles in the solution from depositing on the fluoroplastic surface of the heater, as this can impair heat dissipation, leading to overheating and potential combustion of the heating element.
Electric heating tubes shall be securely positioned and fixed, with the effective heating zone fully immersed in liquid or solid metal. Dry‑burning is strictly prohibited. If oxide scale or carbon deposits are observed on the tube surface, they should be promptly removed before reuse to prevent impaired heat dissipation and reduced service life. At the outlet end of the heating tube, magnesium oxide powder must be protected from contamination and moisture ingress at the installation site to avoid electrical leakage. Components should be stored in a dry environment. If, due to prolonged storage, the insulation resistance falls below… 1ω , can be 200℃ Dry in an oven at room temperature, or reduce the voltage and apply power to heat until the insulation resistance recovers.
An electric heating tube consists of a metal casing, with an alloy resistance wire as the heating element, and lead rods extending from one or both ends. ( line ) . A metal tube filled with magnesium oxide as an insulating medium, housing the heating element. Metal conductive components connected to the heating element, used to link power‑supply‑connected parts and interconnected components. The rated power and the average temperature of the element’s heating surface under full‑heating conditions. In 1.27 Under conditions of twice the rated power and adequate heating, the heating length of the component exceeds the temperature at the high-temperature point. Permissible repair refers to the repair of damaged lead rods, damaged metallic surface coatings, failed insulators, and seals, provided that such repairs do not compromise the component’s performance or normal operation.
Recommended Reading
Spring Heating Wire: A Warm and Harmonious Companion for the Family
2025-02-28
PVC Heating Wire: Bringing Warmth to Your Home
2025-02-18
Aluminum Foil Heating Pad: Bringing Warmth to the Chilly Season
2025-02-08